Eldes EBU1 User Manual download pdf (Page 41)

41EN

ESIM251/ESIM252 User Manual v.2.0

19. MONITORING STATION

The system can be congured to report events to the monitoring station by transmitting data messages to the monitoring station. The

system connects to the monitoring station when the MS (Monitoring Station) mode is enabled.

Enable/disable

MS mode

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

Account is a 4-digit number (By default – 9999) required to identify the alarm system unit by the monitoring station.

Set account

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

ATTENTION: The system will NOT transmit any data to the monitoring station while remote conguration, remote rmware update

or remote listening is in progress. However, during the remote conguration session, rmware update process or remote listening pro-

cess, the data messages will be queued up and transmitted to the monitoring station after the remote conguration session, rmware

update or remote listening process is over.

19.1. Data Messages - Events

The conguration of data messages is based on Ademco Contact ID protocol. The data messages can either be transmitted to the moni-

toring station alone or with duplication by SMS text message to the listed user phone number. For more details on system notications by

SMS text message, please refer to 15. SYSTEM NOTIFICATIONS.

Seq. No. Contact ID® Code Event Description

1 1130 Input alarm Transmitted in case an input is violated.

2 3130 Input restore Transmitted in case an input is restored.

3 1602 Test event Transmitted for system online status verication purposes.

4 3626 Date/time not set Transmitted in case system date & time is not set.

5 1354 GPRS connection loss Transmitted in case the GPRS connection is lost.

Manage data

messages

Cong

Tool

This operation may be carried out from the PC using the ELDES Conguration Tool software.

19.2. Communication

The system supports the following communication methods and protocols:

• GPRS network – EGR100 and Kronos protocol.

• Voice calls (GSM audio channel) – Ademco Contact ID protocol.

Any communication method can be set as primary or backup connection. The user can set up to 5 backup connections in any sequence

order.

Initially, the system communicates via primary connection with the monitoring station. By default, if the initial attempt to transmit data

is unsuccessful, the system will make additional attempts until the data is successfully delivered. If all attempts are unsuccessful, the

system will follow this pattern:

a) The system switches to the backup connection.

b) The system then attempts to transmit data by the backup connection.

c) If the initial attempt is unsuccessful, the system will make additional attempts until the data is successfully delivered. The connection

is considered unsuccessful under the following conditions:

• GPRS network – The system has not received the ACK data message from the monitoring station within 40 seconds.

• Voice calls:

• The system has not received the “handshake” signal from the monitoring station within 40 seconds.

• The system has not received the “kisso” signal from the monitoring station within 5 attempts each lasting 1 second.

e) If one of the attempts is successful, the system will transmit all queued up data messages by this connection.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Comments to this Manuals

No comments

Eldes EBU1 User Manual Page 41

Comments to this Manuals

Related products and manuals for Power supply units Eldes EBU1