136
136 EN
MANUAL ELDES ESIM264 V3.1
32.6.2. Installation
1. Open EWS1 enclosure.
70
71
Insert a thin at-shaped screwdriver or any tool alike into the gap lo-
cated on the back of the enclosure (see Fig. No. 70).
Push the screwdriver down to the right carefully in order to detach
the enclosure parts from each other (see Fig. No. 71).
2. Once the enclosure is opened, remove the plastic tab inserted between one of the battery terminals and battery slot contact (see Fig. No.
72).
72
3. Fix the siren on the wall using the screws (see Fig. No. 73).
BATTERY
RESETLED
+
-
BATTERY
+
-
BATTERY
-
+
73
4. Close EWS1 enclosure. No tools are required for this action.
5. Bind the device to the alarm system by sending a corresponding command via SMS text message or using ELDES Conguration Tool software.
Please, refer to the software‘s HELP section or refer to 19.1. Binding, Removing and Replacing Wireless Devices for more details.
6. The system automatically informs about successful/unsuccessful binding process. If attempt to bind is unsuccessful, try to move EWS1
closer to alarm system device and bind it again.
7. EWS1 siren is ready for use.
NOTE: If you are unable to bind the wireless device please , restore the parameters of the wireless device to default and try again. See
32.6.5. Restoring Default Parameters for more details.
Comments to this Manuals