Eldes EKB3 Installation Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 168
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
23
23EN
MANUAL ELDES ESIM264 V3.1
22
OPEN
23
7. Connect the GSM/GPRS and wireless antennas and follow the recommendations for the installation:
GSM/
GPRS
and/or
wireless
antenna
24
GSM/GPRS
antenna
20 cm
or more
Wireless
antenna
25
8. If one or more wireless devices are to be bound, follow the recommendations for the installation to achieve the strongest wireless
signal:
Wireless
device
26
Wireless
device
Wireless
antenna
0.5 m to 30 m
inside the building
0.5 m to 150 m
in open areas
27
For more details on how to install the wireless devices, please refer to 32. ELDES WIRELESS DEVICES and RADIO SYSTEM IN-
STALLATION AND SIGNAL PENETRATION manual located at www.eldes.lt/download
9. Power up the system.
10. The system starts up in less than a minute. Indicator STATUS should be ashing indicating successful micro-controller operation.
11. The illuminated indicator NETWORK indicates that the system successfully registered to GSM network. To nd the strongest GSM
signal, place the GSM/GPRS antenna and follow the indications provided by NETWORK indicator (see 2.3. Main Unit, LED & Connec-
tor Functi onality).
12. Change the default SMS password (see 6. PASSWORDS for more details).
13. Set the phone number for User 1 (see 8. USER PHONE NUMBERS for more details).
14. Set system date and time (see 9. DATE AND TIME for more details).
15. Once the system is fully congured, it is ready for use. However, if you fail to receive an SMS reply from the system, please check the
SMSC (Short Message Service Center) phone number. For more details regarding the SMS centre phone number, please refer to 27.1.
SMSC (Short Message Service Center) Phone Number.
ATTENTION: The system is NOT compatible with pure 3G SIM cards. Only 2G/GSM SIM cards and 3G SIM cards with 2G/GSM prole enabled
are supported. For more details, please contact your GSM operator.
NOTE: The installation of iButton key reader, EKB2/EKB3 keypad, EWK1 wireless keyfob is not mandatory. However, it is recommended to
have those devices installed as an emergency switch in case your mobile phone is switched o or missing.
NOTE: For maximum system reliability we recommend you do NOT use a Pay As You Go SIM card. Otherwise, in the event of insucient
credit balance on the SIM card, the system would fail to make a phone call or send messages.
Never install in the following
locations:
• inside the metal cabinet
• closer than 20 cm from the
metal surface and/or power
lines
keep the distance of at least 20
cm or more.
Never install in the following
locations:
• inside the metal cabinet
• closer than 20 cm from the
metal surface and/or power
lines
Recommended installation:
• face the front side of the
wireless device towards the
antenna
• keep the distance: 0.5 m to 30
m inside the building, 0.5 m to
150 m in open areas
Recommended installation:
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 167 168

Comments to this Manuals

No comments