152
152 EN
MANUAL ELDES ESIM264 V3.1
Unit Description
Z Zone terminal
COM Common terminal
TAMP1 Tamper switch
+ / - Battery slots
DETECT Magnet detector
LED Light-emitting diode for indication of parameter restoring to default
RESET Button for restoring default parameters
TAMP2 Tamper switch
32.11.2. Installation
1. Remove the cover of EWD2 enclosure.
Press and hold
Insert a screwdriver or
any other tool and push it down
96 97
2. Remove the PCB (printed-circuit-board) from the enclosure.
a) Press and hold
b) Pull up the edge
of the PCB
98
3. Screw in the enclsoure to the door or window jamb.
MOUNTING POINT A
MOUNTING POINT B
Ensure to screw in properly for supervision
of the back side by tamper switch
99
4. Wire up the external digital sensor (if any) or water sensor (if any) to Z and COM terminals, otherwise do not perform any wiring.
5. Insert the PCB back into the enclosure
Comments to this Manuals