Eldes ESIM251 User Manual download pdf (Page 12)

3.5 Remote Microphone Listening

NOTE

To enable this feature it is necessary to connect microphone connector to MIC slot. The microphone is additional equipment

tha can be purchased in trading centers.

You can listen to what is going on in the secured premises by sending the following SMS message:

The system will ring the sender of the received SMS, and upon answering the call, the user can listen to any sounds in the building.

The phone call must be answered within 20 seconds otherwise the system will stop trying and return to previous state.

3.6 Managing C1 Controller. Timer.

GSM control system ESIM251 contains a controller C1- a relay output. It can be used to control various electrical devices such as

electric pumps, heating, lighting etc. When the controller is enabled RELAY connectors are connected.

The device is turned on by sending the following SMS message:

The device is turned o by sending the following SMS message:

Instead of C1 it is also possible writing a real controller name.

E.g.. XXXX_PUMP:ON

Timer

GSM control system ESIM251 has internal timer clock. This feature allows any controlled output to be switched on or o for a spe-

cied time period. The following SMS command should be sent:

ON – output enabled. OFF – disabled

vv – hours, valid values [00-23] mm – minutes, valid values [00-59] ss - seconds, valid values [00-59]

It is not allowed to have all values equal zeros. Zeros it is not allowed to have all values equal

E. g. to switch the pump on for 01 minutes and 23 seconds, send SMS XXXX_PUMP:ON:00.01.23

If the pump was enabled before and user want to disable it for 01 minute and 23 seconds, send SMS

XXXX_PUMP:OFF:00.01.23

If you want to use more C1 Output capabilities as TOGGLE, automatic enabling and disabling for a particu-

lar hour or control, use conguration software „ELDES Conguration Tool“ or see chapter 3.9.2

3.7 SMS Message Delivery to Multiple Users

Upon activated alarm in security system, ESIM251 SMS messages are repeatedly sent until  rst successful delivery to one of the

users. The system starts with NR1 and if delivery fails, it follows with NR2 etc.

It is also possible to set the system so that it sends SMS message to all recorded users.

XXXX_MIC

XXXX_C1:ON

XXXX_C1:OFF

XXXX_C1:ON/OFF:vv.mm.ss

ESIM 251

XXXX_

PUMP:

ESIM 251

XXXX_

PUMP:

OFF:00.

01.23

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Eldes ESIM251 User Manual Page 12