Eldes ESIM251 User Manual download pdf (Page 23)

USER MANUAL ELDES ESIM251 V1.0 23

FOR ADVANCED USERS

All these features can be congured using program “ELDES Conguration Tool“

As per factory default settings SMS message sending feature in the case of alarm is enabled for all users until the rst successful

delivery of the SMS message, it is necessary to remove users NO1 and NO3 and disable alarm calls for all users. It is also necessary to

enableimpulsecountingmodeforESIM251inputZ3andsetthenumberofexpectedimpulses.

a)FirstofallasignalindicatingPUMPtriggeringisconnectedtoESIM251inputZ3.

b) ThefollowingcongurationSMSmessagemustbesenttoESIM251system:

where SC13 means that alarm SMS message sending is disabled for users NO1, NO3 after Z3 zone activation.

CC123 means that alarm calls are disabled for users NO1, NO2 and NO3 after Z3 zone activation.

We make an assumption that users NO4-NO5 were not entered to the system at all.

IE1 enables impulse counting mode for zone Z3. IC10 means that the alarm is given to Z3 input after 10 impulses are transmitted.

Task No2:

 Conguringthesystemsothattheoperatingpersonnelmember(NO2)receivesSMSmessageifthepumpwastriggeredfor10

times.

XXXX_SMSEXTRA:Z3:SC13,CC123,IE1,IC10

Worker

NO1

Worker

NO2

Worker

NO3

Pump

Gas boiler

ESIM151

Automatic

system

Alarm

SMS

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

No comments

Eldes ESIM251 User Manual Page 23